Fittings

Fittings
Standard hot tub plumbing fittings are also known as 'Schedule 40'. This is a reference to the nominal pipe size and the wall thickness of the pipework. Two inch fittings do not measure 2 inches on the inside or outside; but they accept 2 inch schedule 40 pipe (pipe with a nominal size of 2 inches). The actual pipe size must be looked up in a re...
Standard hot tub plumbing fittings are also known as 'Schedule 40'. This is a reference to the nominal pipe size and the wall thickness of the pipework. Two inch fittings do not measure 2 inches on the inside or outside; but they accept 2 inch schedule 40 pipe (pipe with a nominal size of 2 inches). The actual pipe size must be looked up in a reference table.
More

Fittings There are no products in this category.

Subcategories

  • 1" Fittings
    Standard 1 inch fittings
  • 1-1/2" Fittings
    Standard 1-1/2 inch fittings
  • 1/2" Fittings
    Standard 1/2 inch fittings
  • 2" Fittings
    Standard 2" fittings
  • 3/4" Fittings
    Standard 3/4 inch fittings
  • Barb Fittings
  • Extenders
    Plumbing extenders for hot tub pipework. These are great pieces of plastic for getting you out of trouble when re-plumbing spas - there are 2 types : FITTING EXTENDERS : One side fits OVER Schedule 40 plumbing and provides a 2" spiggot. This is especially beneficial if you find that having cut into the pipework you have some pipe left inside the fitting - you would normally need to hollow out the fitting - these extenders sleeve over the fitting. The other side fits INSIDE 2" Schedule 40 plumbing and provides a 2" socket. This is beneficial if you need to extend the fitting just that little bit more, but not quite enough to warrant another fitting or length of pipe. PIPE EXTENDERS : These fittings fit INSIDE flexi pipe and provide a spiggot of the same size. This is beneficial if you need to extend the flexi pipe just that little bit more, but not quite enough to warrant another fitting or length of pipe.
  • Joiners
    Internal plumbing joiners for hot tub pipework.
  • Plugs and Caps
  • Reducers
  • Wye's
  • Reducing Tees
  • Snap fittings

    Snap fittings in 3/4" 1" 1-1/2" and 2"

    These are EXCELLENT pieces of repair plumbing.

    If you have a leaking joint at the point where the pipe enters the fitting, they sleeve over the pipe and push upto the fitting.

    This means you won't need to cut out the fitting and run new pipe etc.

    It is essential that you use ONLY Weld-On 719 glue when using these.